FPV-Community.com

Hi all

The ground station is complete I'm just waiting for some 11.1V 5000mAh lipos to arrive to power the RX; the Pb batteries are too heavy. I just want to cut down on the time it used to take to connect up all the wires and also it means I won’t forget things that I need. I have just replaced the lipos and charger in the bottom of the case with the Futaba TX so now there is less chance of forgetting the TX.

Hi!

Looks good, very clean! But do you have bigger pictures for us?

(11-30-2009 06:29 AM)Grandcaravan Wrote: [ -> ]Hi!

Looks good, very clean! But do you have bigger pictures for us?

Ok I will upload bigger and better pictures in the next few days when I come off night shifts.

Regards

(11-30-2009 10:02 AM)Njoro Wrote: [ -> ]

(11-30-2009 06:29 AM)Grandcaravan Wrote: [ -> ]Hi!

Looks good, very clean! But do you have bigger pictures for us?

Ok I will upload bigger and better pictures in the next few days when I come off night shifts.

Regards

I've done some pictures for now, I will do some more later.

I like it

Hi All

Some more pictures of the latest changes to the ground station. I have changed the battery to a 5000mAh lipo due to the Pb battery weight also I have wired up so a single switch powers the RX and divesity. Although now I'm worried that if the switch fails I'll go blind.

I'm happy for any circuit ideas so that if my main switch fails a backup lipo kicks in?

http://www.youtube.com/watch?v=xFE84hisyzA

http://www.youtube.com/watch?v=91BGVk2iDLk