FPV-Community.com

(10-27-2010 05:53 PM)Grandcaravan Wrote: [ -> ]Nice, very nice
I can see a piano DVR, how's the quality?

The quality is good enough for normal fpv cam's
After conferting to vimeo or youtube it will be more bad.
I am happy with it.
It doesnt like bluescreens.

---

(10-27-2010 06:11 PM)aaron_gx Wrote: [ -> ]roel - I notice you are still using stock motor/motor mount. You might want to double check how secure the stock mount is glued on. Mine tore out and chopped up my fuse when the prop started slapping everything. Just something that might save you some heart-ache

It allready happend
You can see it on my wings.
I need a new plane fast!

Last friday i made some fpv flights with a other fpv pilot nearby.
He had a tracker so i could use his ground station.
The weahter was very good so i got the plane till 500 meters high.
Then the wind took it out of my transmitter range and crashed 1.8km far.
Fast we drove till 1.8km and used the patch if there is any signal from the plane.
We where verry lucky.
Passing farmland water streams and woods we found back my plane.



My Ezosd is damaged and my AR7000 reciever.
The plane is totally crushed.
I have to repair the OSD and need a new plane.







SO I BOUGHT A STRONG PLANE!!!
what do you think about this one?



It has a lot of space for my fpv gear.



Also i will order a tracker patch etc.

Ouch My deepest condolences for you plane
A really bad crash...

Your new plane looks great, Roel!
It would be nice if you can starta build log in a new thread

Best regards
Heiko

Ouch! I know how you feel there bud, on the bright side though, you have a very cool twin motor plane havent seen a voyager before.

(03-28-2010 05:23 PM)Roel-CP Wrote: [ -> ]I was not happy with my 450 so i changed a lot

I took my TREX 500 and started to make 2 skid spoilers on each side.
Like a militairy hospital helicopter where they put on the beds.
Now i have lots of space to mount my FPV and stabilizer gear.
Also the interverance of my brussless motor system is gone .

I am almost ready to go fly FPV now
The OSD is working fine after the update
Just have some settings to do

Pitty the EZOSD does not work on 22 Volt so i took power from the balance cable.
I can fly till 11.1V on the OSD.
A time countdown would be nice.

Here some pics.






http://lh6.ggpht.com/_xy7jkorjU-Q/S69-2s...IMG080.JPG






Setup
Align T-rex 500
Hobbymate 500 motor
Gulang 80A ESC
Towerpro servo',s
Futaba GY-401 + Savox tail servo
Hyperion 6s 2500mAh Lipo x 2
Spektrum AR6100
Spartan AP2000i + FMA sensor
1.3G TX 850mw
EZOSD
12V Camara MSH-36 (Kx191)

Spektum DX7
1.3G RX + Fatshark 2.4G TX 10mw
Fatshark Googles
Toshiba A10 Pro laptop + Dazzle DVC100

nice freaking set up!!!!!